26 Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference
53-1002965-01
MAC address debug commands
3
GVRP: 0x207651e8: 09 cb 04 05 0f a1 04 02 00 02 04 01 00 07 04 01
GVRP: 0x207651f8: 00 09 04 01 00 0b 00 00
GVRP: Port 2/1 TX
GVRP: 0x207651b8: 01 80 c2 00 00 21 00 04 80 2c 0e 20 00 18 42 42
GVRP: 0x207651c8: 03 00 01 01 04 02 00 02 04 01 00 07 04 01 00 09
GVRP: 0x207651d8: 04 01 00 0b 00 00
MAC address debug commands
debug mac
Syntax: [no] debug mac
This command enables the Media Access Control (MAC) address debugging action.
Brocade# debug mac
MAC DB: Action debugging is on
mac_action_request: done->
MA - Normal, ALL_SYST, FLUSH
Ports: All Ports
Vlans: All Vlans
stack: 20B89ED4 2028D708 2028D8A0 201AB040 20C2D58C 20C2EA48 20C2D6DC 20C2EDA4
20C2B2B8 20B8B3A8 2076C3EC 2076C448 20590734 205146FC 20592568 5010 15B4C 1AAD8
Brocade# aging_timer. call mac_action_handler()
MA - Normal, ALL_SYST, FLUSH
Ports: All Ports
Vlans: All Vlans
stack: 20B89ED4 2028D708 20C6FAB0 20B894BC 20514924 20590738 205146FC 20592568
5010 15B4C 1AAD8
mac_clear_request(). NO_ACTION, SPECIFIC
stack: 20B89ED4 2028CD28 2028D1F0 20C6FAB4 20B894BC 20514924 20590738 205146FC
20592568 5010 15B4C 1AAD8
MCT debug commands
Multi-Chassis Trunking (MCT) provides link-level redundancy and load sharing in addition to
increased capacity. If any one of the MCT cluster device fails, the data path remains operational
through the other MCT cluster device without any disruption.
This section describes the debug commands that display MCT information.
debug cluster all
Syntax: [no] debug cluster all
This command enables or disables the MCT debugging information log.
If the debug cluster all command is enabled, the output similar to the following is displayed.
Brocade# debug cluster all
MCT:: Enabling all debugs
CLUSTER ALL debugging is now ON
Brocade# rstp_txRSTP(T=25364)(vlan=20,port=1/15) Tx on CCEP, MCT peer is superior
To Next Page
Loading...
Need help?
General
