Brocade Communications Systems FastIron X Series Diagnostic Manual

128 Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference
53-1002965-01
IGMP debug commands
6
Brocade# debug ip msdp events
: MSDP: 10.120.120.45: Process START event, local = 10.120.120.31
: MSDP: S=xxxxxxx P=0 Initiate Transport Connection to MSDP peer
: MSDP: 10.120.120.45: TCP Connection to Remote Peer is Open
: MSDP: 10.120.120.45: MSDP-TCP Connection opened
: MSDP: 10.120.120.45: TCP_OPEN DONE, State 4
: MSDP: Remote Peer closed TCP connection
: MSDP: 10.120.120.45 Remote Peer closed TCP connection
: MSDP: Originating SA
: MSDP: Originating SA
: MSDP: Originating SA
: MSDP: Originating SA
: MSDP: Originating SA
debug ip msdp message
Syntax: [no] debug ip msdp message
This command generates information about MSDP messages received, transmitted and forwarded,
and flag errors in the MSDP messages.
Brocade# debug ip msdp message
: MSDP: 10.0.0.32: Xmt KA
: MSDP: 10.0.0.32: State=4, Rcv SA 20 bytes
RP: 10.0.0.32, Num SA: 1 10.17.17.1,237.14.18.3
: MSDP: 10.0.0.32: State=4, Rcv KA
: MSDP: 10.0.0.32: State=4, Rcv SA 20 bytes
RP: 10.0.0.32, Num SA: 1 10.17.17.1,237.14.18.3
: MSDP: 10.0.0.32: State=4, Rcv KA
: MSDP: 10.0.0.32: Xmt SA 32 bytes
RP: 10.0.0.45, Num SA: 2 10.14.14.14,237.14.18.3 10.17.17.1,237.14.18.3
: MSDP: 10.0.0.32: Xmt KA
: MSDP: 10.0.0.32: State=4, Rcv SA 20 bytes
RP: 10.0.0.32, Num SA: 1 10.17.17.1,237.14.18.3
IGMP debug commands
The Internet Group Management Protocol (IGMP) allows an IPv4 system to communicate IP
multicast group membership information to its neighboring routers. The routers in turn limit the
multicast of IP packets with multicast destination addresses to only those interfaces on the router
that are identified as IP multicast group members.
The following commands display the information related to IGMP debugging.
debug ip igmp add-del-oif
Syntax: [no] debug ip igmp add-del-oif
This command displays information about the addition or deletion of the outgoing interfaces (OIFs).
Brocade# debug ip igmp add-del-oif
add-del-oif enabled
Brocade# debug ip igmp show
igmp debug-enable-any = 1
debug ip igmp add-del-oif is enabled
Brocade# debug ip igmp
Brocade# IGMP: rcvd Report-V2(t=22) g=239.0.0.147 resp=100, pkt S=10.17.17.222 to
239.0.0.147, on v17 (phy 2/1/17), igmp_size=8

Brocade Communications Systems FastIron X Series Specifications

General

Brand	Brocade Communications Systems
Model	FastIron X Series
Category	Switch
Language	English