Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 71
53-1002965-01
NTP debug commands
4
debug rip events
Syntax: [no] debug rip events
This command displays RIP events.
Brocade# debug rip events
Brocade(config-vif-11)# RIPng: update timer expired
clear ipv routeRIPng: triggered update
RIPng: garbage prefix 2001:DB8::/64 timer 1, metric 0, tag 0
from :: on interface NULL
RIPng: garbage prefix 2001:DB8::/64 timer 1, metric 0, tag 0
from :: on interface NULL
RIPng: Adding local connected route 2001:DB8::1/64 on interface v11
RIPng: Adding local connected route 2001:DB8::1/64 on interface v12
RIPng: update timer expired
RIPng: Redistribute add route 2001:DB8::/64, type CONNECTED (1/0)
RIPng: Redistribute add route 2001:DB8::/64, type CONNECTED (1/0)
NTP debug commands
This section describes the debug commands that generate debugging information about the NTP
configurations.
debug ip ntp
Syntax: [no] debug ip ntp [algorithms | association | broadcast | clockadjust | errors | packet |
server]
• algorithms - Displays information about the NTP system algorithms.
• association - Displays information about the NTP server and peer association.
• broadcast - Displays information about the NTP broadcast server and client.
• clockadjust - Displays information about the NTP clock-adjust process.
• errors - Displays information about the NTP error events.
• packet - Displays information about the NTP input and output packets.
• server - Displays information about the NTP server.
debug ip ntp algorithms
Syntax: [no] debug ip ntp algorithms
This command displays information about the NTP system algorithms. Command output resembles
the following example.
Brocade# debug ip ntp algorithms
NTP: ntp_peer_unfit: dist exceeded - root dist 16.00527999 of peer 10.25.96.13 has
exceeded max dist 1.50096000
NTP: ntp_peer_unfit: unreachable - peer 10.25.96.13 is not reachable [peer->reach
0]
Brocade(config-ntp)# NTP: ntp_clock_filter: Adding offset 0, delay 0, disp 16 to
filter[0] for peer 10.25.96.13
NTP: ntp_clock_filter: No acceptable samples available
NTP: ntp_clock_filter: Adding offset 0.01133625, delay 0.27379156, disp
0.00001936 to filter[1] for peer 10.25.96.13
To Next Page
Loading...
Need help?
General
