Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 81
53-1002965-01
VRRP and VRRP-E debug commands
4
VRRP and VRRP-E debug commands
Use the following commands to filter the Virtual Router Redundancy Protocol (VRRP) and Virtual
Router Redundancy Protocol - Extended (VRRP-E) messages for IPv4 or IPv6, and to debug specific
IPv4 or IPv6 packets within the router.
debug ip vrrp packet
Syntax: [no] debug ip vrrp packet
This command displays debugging information of any VRRP or VRRP-E packets within the device.
Brocade# debug ip vrrp packet
VRRP: packet debugging is on
VRRP (IPv6): send advertise! ver:3 type:1 vrid:100 pri:255 num of ip:1 adv:100
chk:44853
Num of ip addr 1
2000::7:1
VRRP (IPv4): rcvd packet! ver:2 type:1 vrid:10 pri:255 #ip:1 aut:0 adv:1
chk:52198
Num of ip addr 1 10.10.10.2 from sender 10.10.10.2
VRRP (IPv6): rcvd packet! ver:3 type:1 vrid:10 pri:255 #ip:1 aut:0 adv:100
chk:53518
Num of ip addr 1
fe80::7:2 from sender 2000::7:2
VRRP (IPv6): rcvd packet! ver:3 type:1 vrid:11 pri:255 #ip:1 aut:0 adv:200
chk:53417
Num of ip addr 1
fe80::8:2 from sender ::
debug ip vrrp packet v4
Syntax: [no] debug ip vrrp packet v4
This command displays debugging information of VRRP or VRRP-E packets specific to IPv4 within
the device.
Brocade# debug ip vrrp packet v4
VRRP (IPv4): packet debugging is on
VRRP (IPv4): rcvd packet! ver:2 type:1 vrid:10 pri:255 #ip:1 aut:0 adv:1 chk:52198
Num of ip addr 1
10.10.10.2 from sender 10.10.10.2
VRRP (IPv4): rcvd packet! ver:2 type:1 vrid:10 pri:255 #ip:1 aut:0 adv:1 chk:52198
Num of ip addr 1
10.10.10.2 from sender 10.10.10.2
VRRP (IPv4): rcvd packet! ver:2 type:1 vrid:10 pri:255 #ip:1 aut:0 adv:1 chk:52198
Num of ip addr 1
10.10.10.2 from sender 10.10.10.2
debug ip vrrp packet v6
Syntax: [no] debug ip vrrp packet v6
This command displays debugging information of VRRP or VRRP-E packets specific to IPv6 within
the device.
To Next Page
Loading...
Need help?
General
