Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 183
53-1002965-01
supportsave commands
8
The following is the sample output from the supportsave info enable command.
Brocade# supportsave info enable
Brocade# show flash
===========show flash===========
HW:FCX624S-HPOE-PREM, Label:FCXR08000b1, Started at 11:33:06.458 GMT+00 Fri Dec
07 2012
Stack unit 1:
Compressed Pri Code size = 7199468, Version:07.4.00T7f3 (FCXR07400C005.bin)
Compressed Sec Code size = 8637789, Version:08.0.00T7f3 (FCXR08000b1.bin)
Compressed Boot-Monitor Image size = 370611, Version:07.3.00T7f5
Code Flash Free Space = 48103424
FCX624SHPOE-ADV Router#
===========END OF A COMMAND===========
Brocade# show module
===========show module===========
HW:FCX624S-HPOE-PREM, Label:FCXR08000b1, Started at 11:33:06.464 GMT+00 Fri Dec
07 2012
Module Status Ports Starting MAC
U1:M1 FCX-24GS POE 24-port Management Module OK 24 0000.00bc.2c00
U1:M2 FCX-2XGC 2-port 16G Module (2-CX4) OK 2 0000.00bc.2c19
FCX624SHPOE-ADV Router#
===========END OF A COMMAND===========
supportsave info disable
Syntax: supportsave info disable
This command disables the header to be displayed for all show commands being executed on CLI.
Recovery during continuous reload
Perform the following steps to collect the logs in case of continuous reload of the device on a given
partition:
• Press b to stop reloading in boot prompt.
• Boot from the stable firmware from the other partition using boot_primary or boot_secondary
options.
• Run supportsave command to collect the logs after the reload is finished with the stable
firmware.
• Execute the use default-configuration command from the boot prompt for stopping the start up
configuration during reload, and make sure the device loads successfully. Otherwise, contact
the Brocade technical support for assistance.
To Next Page
Loading...
Need help?
General
