Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 45
53-1002965-01
Packet-capture debug commands
3
Packet-capture debug commands
The following debug packet-capture command helps to debug packet flows and capture packets
designated for the management module for debugging. This command has additional filter and
mode option parameters for refining the traffic sources and the format of the saved data.
debug packet-capture
Syntax: [no] debug packet-capture [ all | count-reset | count-show | exclude-mgmt-port | filter |
max | mode | no-limit | no-mgmt-port | receive | send ]
• all—Displays the debugging information of the packets transmitted and received.
• count-reset—Clears the total packet count of the packets captured.
• count-show —Displays the total packet count of the packets captured for debugging.
• exclude-mgmt-port—Enables debugging of the packets that are excluded for the management
port.
• filter—Enables the raw packet filter for debugging.
• max—Displays the maximum number of packets.
• mode—Displays the various packet modes.
• no-limit—Displays the debugging information of an unlimited number of packets.
• no-mgmt-port—Toggles the display of packets from the management port.
• receive—Debugs only the packets that are received.
• send—Debugs only the packets that are transmitted.
The debug packet-capture command displays information about packet-capture activity.
debug packet-capture filter
Syntax: [no] debug packet-capture filter filter_index filter_options
The filter_index parameter specifies the filter number. The decimal value ranges from 1 through
20.
The filter_options parameter specifies the filter option. The following are the various options in
filter:
• all—Matches all packet
• arp—Matches an ARP request or response
• broadcast-mac—Matches the destination broadcast MAC address (0000.00FF.FFFF)
• cdp—Matches with the CDP
• clear—Clears the filter entry
• clear-counter—Clears the counter
• cpu-code—Matches the CPU code
• da—Matches the destination MAC address
• dhcp—Matches with the DHCP
• dot1x—Matches the dot1x protocol
• dpa—Matches the destination IP address
• dport—Matches the destination protocol port
To Next Page
Loading...
Need help?
General
