46 Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference
53-1002965-01
Packet-capture debug commands
3
• ether-type—Matches the Ethernet type packets
• fdp—Matches wit h the FDP
• in-port—Matches the input port
• l2-802.1w—Matches the 802.1w BPDU
• l2-lacp—Matches the LACP PDU
• l2-mstp—Matches the MSTP BPDU
• l2-stp—Matches the spanning tree BPDU
• l3-bgp—Matches with the BGP
• l3-ospf—Matches the OSPF protocol
• l3-vrrp—Matches the VRRP
• l3-vrrpe—Matches the VRRP-E
• lldp—Matches the LLDP
• mrp—Matches the MRP
• out-port—Matches the output port
• priority—Matches the priority
• protocol—Matches the IP
• pvst—Matches the PVST protocol
• sa—Matches the source MAC address
• snmp—Matches the SNMP
• spa—Matches the source IP address
• sport—Matches the source protocol port
• udld—Matches the UDLD protocol
• vlan-id—Matches the VLAN ID
• vsrp—Matches the VSRP
This command enables the filter option for the raw packets. There are 32 filter options that can be
configured within a single filter. The filter index limit ranges from 1 through 20.
Brocade# debug packet-capture filter 2 protocol
debug packet-capture mode
Syntax: [no] debug packet-capture mode [brief | no-display | normal | pcap-fmt
[default | decimal]]
• brief—Specifies the increment counters and displays the packet summary.
• no-display—Specifies the increment counters alone.
• normal—Specifies the increment counters and displays the packet header and the first 48 raw
bytes.
• pcap-fmt—Specifies the increment counters and dumps the packet in pcap (packet capture)
hexadecimal format.
• default—Specifies the normal mode.
• decimal—Specifies the first 48 bytes of the packets received.
This command displays the format of the packets to be captured for debugging information.
To Next Page
Loading...
Need help?
General
