viii Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference
53-1002965-01
The Brocade ICX 6450-C12-PD switch supports the same feature set as the Brocade ICX 6450
switch unless otherwise noted.
Some debug commands report information about internal hardware settings and registers that is
relevant primarily to the Brocade engineering staff. Consequently, this information is not described
in this document.
Unsupported features
Features that are not documented in “Related publications” on page x are not supported.
Audience
This document is designed for network engineers with a working knowledge of Layer 2 and Layer 3
switching and routing.
If you are using a Brocade Layer 3 switch, you should be familiar with the following protocols if
applicable to your network – IP, RIP, OSPF, BGP, ISIS, IGMP, PIM, DVMRP, and VRRP.
Disclaimer
This manual is provided without any warranty of any kind, expressed or implied. When using this
manual to troubleshoot Brocade products, you assume all risk as to the quality and performance of
the debug procedures. Brocade assumes no liability for any damages, including general, special,
incidental, or consequential damages arising from the use of the procedures in this manual
(including, but not limited to any loss of profit or savings, loss of data, or failure to successfully
troubleshoot network problems).
Debug information may be changed or updated without notice. You are responsible for obtaining
newer versions of this manual when they are made available. The procedures in this document are
not intended as a substitute for the expertise of qualified technicians.
Enabling debug commands can seriously degrade system performance. Debug commands are
generally intended for use when troubleshooting specific problems while working with qualified
service technicians, or in conjunction with calls to Brocade Technical Support. Whenever possible,
troubleshoot your system during periods of low network traffic and user activity to preserve system
performance.
If you have any questions regarding this disclaimer please contact us at
http://www.brocade.com/products/all/routers/index.page.
What’s new in this document
There are no enhancements for FastIron release 08.0.01.
To Next Page
Loading...
Need help?
General
