Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 49
53-1002965-01
debug pp-trunk-hash
3
registered-multicast
Generates debugging information related to registered multicast distribution.
The following variables must be specified with this option.
vlan Specifies the VLAN ID.
vidx Specifies the multicast ID.
routed-flow Generates debugging information related to routed flow distribution. The
following variables must be specified with this option.
dst_ipv4 Specifies the destination IPv4 address.
src_ipv4 Specifies the source IPv4 address.
IPHdr_Protocol Specifies the protocol value in the IP header.
switched-flow ip
Generates debugging information related to switched flow IPv4 and IPv6
distribution. The following variables must be specified with this option.
dst_ipv4 Specifies the destination IPv4 address.
src_ipv4 Specifies the source IPv4 address.
switched-flow non-ip
Generates debugging information related to switched flow non-IP distribution.
The following variables must be specified with this option.
dmac Specifies the destination MAC address.
smac Specifies the source MAC address
unregistered-multicast vlan
Generates debugging information related to unregistered multicast
distribution for the specified VLAN ID.
v6-device Generates debugging information related to the IPv6 device. The following
parameters are supported with this option.
routed-multicast-distribution vlan
Generates debugging information related to routed multicast distribution for
the specified VLAN ID.
unicast-distribution
Generates debugging information related to unicast distribution.
ip Generates debugging information related to unicast IP distribution.
non-ip Generates debugging information related to unicast non-IP distribution.
Modes Privileged EXEC mode
Usage
Guidelines
The debug pp-trunk-hash trunk_port command is supported only on Brocade FCX and Brocade ICX
devices.
The debug pp-trunk-hash ingress_ port command is supported only on Brocade FastIron SX
devices.