Brocade FastIron, FCX, ICX, and TurboIron Diagnostic Reference 69
53-1002965-01
OSPF debug commands
4
OSPF: validate route, new->valid 192.168.30.0, state 3, path type 3
debug ip ospf retransmission
Syntax: [no] debug ip ospf retransmission
This command generates internal information about OSPF retransmission of LSAs.
Brocade# debug ip ospf retransmission
Brocade(config)# clear ip routeOSPF: examine each neighbor and add advertisement
ls-id 10.3.13.0 to the retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.3.13.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.1.2.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.1.2.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.3.3.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.3.3.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.1.2.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.1.2.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.24.2.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.24.2.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.3.3.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.3.3.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.3.13.0 to the
retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.3.13.0 to the
retransmission list if necessary
Brocade(config)# OSPF: examine each neighbor and add advertisement ls-id 10.24.2.0
to the retransmission list if necessary
OSPF: examine each neighbor and add advertisement ls-id 10.24.2.0 to the
retransmission list if necessary
debug ip ospf spf
Syntax: [no] debug ip ospf spf
This command generates information about OSPF Shortest Path First (SPF) activity including SPF
runs and calculations. Command output resembles the following example.
Brocade# debug ip ospf spf
OSPF: spf-short debugging is on
Disable neighbor
Brocade(config-ospf-router)# Debug: Jan 1 02:38:55 OSPF: Schedule SPF(8001), in
prog 0, ospf build_routing_table 0 phase 1
Debug: Jan 1 02:38:55 OSPF: schedule spf, init spf delay 0, next hold 0 (ticks)
Debug: Jan 1 02:38:55 OSPF: Add to spf pending list, current time 96788,
scheduled 96788, next run 96788
Debug: Jan 1 02:38:55 OSPF: Schedule SPF(7001), in prog 0, ospf
build_routing_table 0 phase 1