Brother GT-3 Series - Page 152

6. Replacing Parts
Ass
e
mbling
1. Mount the Origin Sensor to the Sensor Holder.
<Note> First hook the claw (1) and then hook the two claws (2).
(1)
(2)
2.
Con
nect the Harness: Platen Origin (3) to the Connector (4).
(3)
(4)
3. Fix the Senso
r Holder (5) with the one Screw (6).
<Note> Mount the Sensor Holder with fitting the two projecting points of the Sensor Holder (B) with the
two positioning holes (A) on the Guide Support Plate R.
GT-3 Series
143
(5)
(A)
(6)
(B)