Brother GT-3 Series - Panel Body Assy

6. Replacing Parts
6-2-13. Panel Body Assy
Required Tools
・3 mm Hexagonal wrench
Disassemble
1. Remove the Cover DR (right side). (Refer to “6-1-2. Assembling/Disassembling of the Covers”.)
2. Remove the Cover of the Control Box. (Refer to “6-2-10. Power Unit”.)
3. Remove the twelve Screws (2) that fix the Cover PF (1).
Pull out the Cover PF slowly to your side.
GT-3 Series
330
4. Remove the f
our Bolt Sockets (3) on the both sides of the Panel Body Assy with the Hexagonal wrench.
(
2
)
(2)
(2)
(
2
)
(2)
(1)
(3)
(3)