Brother GT-3 Series - 3. Getting Started

2. Setting up GT-3 Series
2-3. Levelling GT-3
Use a spirit level to level the GT-3.
1. Place the spirit level (1) on the Platen in the lateral direction as shown below.
(1)
2. Loo
sen the four nuts (3) of the Adjusters (2) at the bottom of the Main Frame.
(2)
(3)
(2)
(3)
3. Rotate the Ad
justers (2) to adjust the levelness in the lateral direction by less than 1 mm/.
・Rotate the Adjuster CLOCKWISE to raise the printer.
・Rotate the Adjuster COUNTERCLOCKWISE to lower the printer.
<Note> Adjust the adjuster (2) within 32 mm. See the image below.
32 mm or shorter
(2)
(3)
0022N
18 GT-3 Series