Brother GT-3 Series - Lithium Battery

6. Replacing Parts
6-2-21. Lithium Battery
Adjust the firmware with GT-3 Service Tool, after you replace to the new Lithium Battery. (Refer to “3-3. GT-3
Service Tool”.)
Required Tools
・ Thermistor
Disassembling
1. Remove the Cover DR (right side). (Refer to “6-1-2. Assembling/Disassembling of the Covers”.)
(1)
2. Remove the
Lithium Battery (1) by pulling out the holder in the direction of the arrow.
(1)
(1)
3.
Pic
kup the Lithium Battery (1) to the direction of the arrow.
(1)
4.
Follow the
reverse steps in reassembling.
GT-3 Series
342