Brother GT-3 Series - Page 338

6. Replacing Parts
13.
At prese
nt all the Harnesses from the Control Box are removed by the step (1) to (13). Arrange those
Harnesses neat around the inlet (black grommet) of the Control Box.
14. Remove the four screws (24) that fix the Control Box Assy.
(24)
15. Rotate the Control box by 90 deg
rees, the right side of the Control Box to backward, and the left side to
front side, and then remove the Box. Pay attention not to get damaged to those Harnesses.
16. Follow the
reverse steps in reassembling.
GT-3 Series
329