Brother GT-3 Series - Page 155

6. Replacing Parts
<Referen
ce>
If the actual print position is top margin = 5 mm and the bottom margin = 9 mm, then move the Platen
Sensor Dog to the backward by 2 mm then the both margins will be 7 mm, increasing the top margin by 2
mm and decreasing the bottom margin by 2 mm.
9
5
Move the Platen
Sensor Dog backward
by 2mm
7
7
4. Adjust the top
/bottom margins almost equal, the differences within 3 mm, by repeating the step (2) to (5)
in the above.
5. Mount the Cover PF and Cover DL. (Refer to “6-1-2. Assembling/Disassembling of the Covers”.）
GT-3 Series
146