Brother GT-3 Series - Page 160

6. Replacing Parts
Adjustment
of the Lev
el by four Height Adjustment Screws
1. Loosen the Screw (1).
GT-3 Series
151
2. Loosen the Nut M8 P1 (3) with fitting the MINUS driver (4) in the groove of the Height Adjustment Screw
(2).
(1)
3. Adjust the hei
ght of the Height Adjustment Screw (2) by screwing the MINUS driver.
Clockwise: the height of the Platen goes up.
Counterclockwise: the height of the Platen goes down.
<Note> Rotate the Height Adjustment Screw by 1/4 or even 1/8 so that you can understand how much
you have adjusted.
(3)
(3)
(2)
(4)
(3)
(2)
4. Fix the Nut M8 P1 (3)
with the MINUS driver set in the groove of the Height Adjustment Screw.