6. Replacing Parts
Adjustment
1. Turn ON the printer and execute the I/O Check. (Refer to “3-1-3. How to go to Advanced Menu”.)
2. Confirm the Flap on the Display; ON when you lower the Sensor Flap to the lowest bottom with your
hand, OFF when the Sensor Flap moves by approx. 0.5mm naturally when you release your hand. If the
Flap Sensor will not switch OFF/ON, then loosen the Nut (11) and rotate the Bolt Socket (12) to adjust
the switching position.
Lower the Fla
to the lowest bottom
ON
OFF
It moves back naturally by 0.5 mm.
GT-3 Series
164
To Next Page
Loading...
