6. Replacing Parts
10.
Pick the pla
stic bag on your right hand with your left hand, and wrap the Wiper Cleaner with the plastic
bag.
0060Y
11. Remove the wrapped Wiper Cleaner carefully, not to drop waste ink and dispose of in accordance with
local regulations
GT-3 Series
172
0061Y
<Note>
Pay attention not to soil the Timing Belt and the other parts with waste ink.
Asse
mbling
1. Mount the new Wiper Cleaner by following the reverse steps 4 to 6 in reassembling above.
<Note>
Do not give stress to the Timing Belt in mounting the Wiper Cleaner.
If your printer turns on with no errors, replacement of the Wiper Cleaner has been completed
successfully. Turn off your printer and check if the Wiper Cleaner is correctly mounted if something
irregular occurs, e.g. abnormal noise or error "No Wiper Cleaner (CMYK/White)".
0066Y
To Next Page
Loading...
