Brother GT-3 Series - Page 202

6. Replacing Parts
2.
Fix the Clean
er Sensor Holder B (4) with the Screw (5), with tightening torque 0.8 N·m.
(5)
(5)
(4)
(4)
3. Fix the four Scre
ws of the Cord Clamp (6) and connect the Connector (8).
Lift of the Harness must be
less than 13 mm
(6)
(6)
(7)
(8)
(6)
(8)
(7)
4. Mount the Wi
per Blade Assys and the Wiper Cleaners.
5. Mount the Maintenance Unit. (Refer to “6-1-16. Assembling / Disassembling of the Maintenance Unit”. )
6. Confirm the initial operation, which is OK with no Wiper errors occur.
GT-3 Series
193