6. Replacing Parts
GT-3 Series
199
3. Fix the W Sensor Holder with the Screw with tightening torque 0.5 N·m.
4. Connect the Connector.
5. Mount the Maintenance Unit. (Refer to “6-1-16. Assembling / Disassembling of the Maintenance Unit”.)
Reconfirmation
1. Turn ON the printer and select [ Output Check ] > [ Wiper Test ] in the Advanced Menu. (Refer to “3-1-3.
How to go to Advanced Menu” and “3-1-5-3. Output Check”.)
2. Move the Carriage out of the Maintenance Unit by hand when the Caps are down, and confirm that the
Wiper should move [ to Center ] or [ to Both Ends ] properly.
3. Push the Stop Button to move the Carriage to the home position and turn OFF the printer.
To Next Page
Loading...
