Brother GT-3 Series - Page 218

6. Replacing Parts
5.
Con
nect the Y-shaped Tube Joints (4) and the Joint Tubes (5). Insert the Joint Tubes within 1 mm from
the edge.
(5)
(
4
)
6. Con
nect the Y-shaped Tube Joints (4) and the Capping Tubes (6). Make sure that those tubes should
cross as shown below.
1mm or less
(6)
(4)
0025N
(4)
(4)
(6)
7. Con
nect the T-shaped Tube Joint (7) and the Connecting Tube (8), and the Capping Tube (9).
(9)
(7)
(8)
GT-3 Series
209