Brother GT-3 Series - Page 223

6. Replacing Parts
3. Loosen the Screw (2) and remove the Guard Bar (1). Use a coin to loosen the Screw (2). . Loosen the Screw (2) and remove the Guard Bar (1). Use a coin to loosen the Screw (2).
(1)
(2)
4.
Remove the f
ive screws (3) and dismount the Cartridge Front Cover. 4. Remove the five screws (3) and dismount the Cartridge Front Cover.
(3)
(3)
5.
Remove the t
wo Screws (3) and remove the two Clamps, NK-18N (4). 5. Remove the two Screws (3) and remove the two Clamps, NK-18N (4).
(4)
(3)
6.
Remove the f
our Screws (5) to loose the two Tube Holder Fixes (6). 6. Remove the four Screws (5) to loose the two Tube Holder Fixes (6).
<Note> Do not disassemble the Tubes from the Tube Holder Fixes. <Note> Do not disassemble the Tubes from the Tube Holder Fixes.
(6)
(5)
214
GT-3 Series