Brother GT-3 Series - Page 250

6. Replacing Parts
4.
Mount the Sp
iral 258 (3) on the Tube.
<Note> Wrap the Spiral 258 (3) over the Middle Tube (2) and prevent its edge from touching the Tube
directly.
OK
NG
5. Remove the
Joint VRSP6 (7) to cover the Tube and connect the Tube to the Joint VRFT6 (4).
<Note> Rotate the Joint by 30-40 degrees where you insert. Do not twist or push in, otherwise the Joint
may be damaged.
6. Fix the Tube with the Wire Saddle (5).
(5)
(4)
GT-3 Series
241