Brother GT-3 Series - Page 255

6. Replacing Parts
17.
Apply some d
istilled water around the outside of Tube (C).
<Note>
Without distilled water, Tube may move round with Tube Clamp and it may kink.
Do not put distilled water INSIDE the tube, the ink may be damaged.
(
C
)
18. Fix the Tube with the Tube
Clamp D3 (19).
<Note> Insert the Tube and Tube Clamp D3 (19) until the edge of the Tube Clamp D will touch the nut 8
(20).
Until both edges can touch each other
(20)
(19)
(19)
19. Remove the t
wo Screws (21) and remove the Maintenance Cover (22).
(22)
(21)
GT-3 Series
246