6. Replacing Parts
22.
Move the Ca
rriage (24) back to the Maintenance Position and move up the Caps by rotating the Gear.
<Note>
Confirm the clearance by 10 mm between the Carriage Guide Shaft Support (25) and the Carriage (24).
(25)
(24)
23. Mount the Ma
intenance Cover (22) with the two Screws (21).
(22)
(21)
24. Mount the Front Cover
UF, Cover UB and the Cover Cartridge. (Refer to “6-1-2. Assembling/
Disassembling of the Covers”.)
25. Turn ON the printer.
26. Load the Maintenance Solution first and then load the White Ink. (Refer to “2-6-2.Installing Ink”.)
GT-3 Series
248
To Next Page
Loading...
