Brother GT-3 Series - Page 264

6. Replacing Parts
22.
Remove the Tube from the Tube Joint VRFE6 (20).
<Note>
・ Rotate the Joint VRFT 6 to the arrow direction in the photo by holding the fitting position of the Tube.
・ Pay attention to the ink flowing out from the Tube in disconnecting; it may give damage to your hands,
the printer and the table.
(20)
Do not give stress to the upper and
lower Tubes in disconnecting; it may be
damaged.
23.
Insert the Tube Joint VRSP6 (21) for protection into the Joint VRFE6 (20).
(21)
24.
Remove the
old Tube from the printer.
<Note> Pay attention not to hook the Tubes in operation.
GT-3 Series
255