Brother GT-3 Series - Page 268

6. Replacing Parts
10.
Mount the Tu
be Holder Support (9) on the Tube Holder Support Shaft (10) and fix them with the one Bolt
Socket (11).
<Note> Pay attention not to hook the Tubes in operation.
(
(10)
(11)
9)
11.
Wrap the Tub
e with the Tube Holder Unit as shown in the figure below.
The Slit of the Round Tube Holder
12.
Fix the Tube Holder Fix (12) with the two Screws (13).
3~7 mm
(13)
(12)
GT-3 Series
259