Brother GT-3 Series - Page 285

6. Replacing Parts
GT-3 Series
276
3. Connect the new Tube D3XL200 Supply to the Ink Return Valve Assy as shown in the photos below.
<Note>
Insert the Tubes at least 7.5mm or more from the edge of the Joint on the Ink Return Valve Assy.
4. Push the Stop Lever to release the lock and close the Front Cover UF with both hands.
5. Load the Ink inside the Tubes. Prepare the Maintenance Cartridge W and Maintenance Solution for
White Ink and follow the process in “2-6-2. Installing Ink”.
6. Print the Nozzle Check Pattern to confirm the print quality. (Refer to “2-6-2. Test Print”)
GT-361
GT-381
Ｗ1
Ｗ2
Ｗ3
Ｗ4
Ｗ1
Ｗ2
(2)
Tube D3XL200
Supply
7.5mm or more
Ｗ3
G
T-
38
1
Ｗ1
Ｗ2
Ｗ4
G
T-
36
1
Ｗ1
Ｗ2
Cap VCP-3