Brother GT-3 Series - Page 30

2. Setting up GT-3 Series
7. Rotate the Lever (5) to your side that fixes the Print Head.
GT-3 Series 21
8.
Mount the ne
w Print Head on the printer. Fit the V-shaped groove (1) to the Positioning Pin (2) (right) at
the back of the mounting position.
9. Hold the knob of the Print Head (3) (left) and push it downward so that the V-shaped groove can fit the
inside of the Positioning Pin (2). Push down the Print Head to fix the corner of the Print Head by the Flat
Spring (4) (right).
(1)
Nozzle
surface
(2)
(2)
(4)
(5)
10.
Rotate the Lever to fix the
Print Head.
2
4
3
Slide the Print Head into the Flat
Spring from the right to the left.