Brother GT-3 Series - Page 312

6. Replacing Parts
7. Rem
ove the three Scre
ws (11), dismount the Needle Bracket (4) with the Needles on, and put it on the
paper/cloth of the Cartridge Base (5) as shown in the right photo.
GT-3 Series
303
(6)
(4)
<Note>
・ Pay attention not to fold, crush the T
ube
s in operation.
・ Do not make Needles downward, or the ink may come out from the Needles naturally. Pay attention
in putting it on or moving. Ink may drop on Ink Cartridges, the table and the floor.
8. Remove all the Needle Felts from the Needles by following the steps 1) to 4).
1) Take the edge of the Needle Felt with Tweezers (photo A).
2) Add a cut (a) with scissors on the Felt (photo B and C).
3) Pluck all the Needle Felt with Tweezers (photo D).
<Note>
Do not pull out the Needle Felt (12) from the tip (b) of the Needle; the small fiber may go into the Needle
and give damage to the Print Head.
(12)
A
B
C
D
(a)
(b)
(5)
(11)