Brother GT-3 Series - Page 315

6. Replacing Parts
4.
Remove all th
e Needle Felts (2) one by one from the Needles.
1) Take the edge of the Needle Felt with Tweezers (photo A).
2) Add a cut (a) with scissors on the Felt (photo B and C).
3) Pluck all the Needle Felt with Tweezers (photo D).
<Note>
Do not pull out the Needle Felt (12) from the tip of the Needle; the small fiber may go into the Needle and
give damage to the Print Head.
(2)
(a)
C
A B
4)
Remove tho
se remained ink (b) and the double-sided adhesive tape (c) as shown in the photo
D with the Clean Stick (d) with Maintenance Solution applied (see photo E) to make them clean
as shown in the photo F.
<Note>
Use the Mirror to confirm if the Needle should be clean.
(b)
(c)
(d)
F
D E
5.
Confirm if all t
he Needles are clean with no Needle Felts remained, then agitate the White Ink Cartridges
and load the Ink inside the Tubes. Follow the steps 11-14 in the Process 1.
GT-3 Series
306