2. Setting up GT-3 Series
14. Mount the Plastic Cover over the Carriage PCB. Put it on the Carriage PCB in curl (left), and make the
Condenser (big black part on the Carriage PCB) go through the hole of the Plastic Cover (right).
15.
Put the Plastic Cover so that the fold at the back should cover the metal plate under the Carriage PCB.
16.
Put the two screws through the holes on the front side of the Plastic Cover (left), and apply the silicone
tubes to the screws that were removed in the step 6.
17. Put the claws on the Plastic Cove
r removed in the step 5 (left), and finally connect the Harness.
18. Push the Sto
p Lever to release the lock when you close the Front Cover with both hands.
24
GT-3 Series
To Next Page
Loading...
