Brother GT-3 Series - Page 364

8. Error Code List
GT-3 Series
355
Error
code
Message Meaning
Solution
1060 Temp Low:
The ambient temperature is
below the range that maintains
the print quality. “xxx” is the
current temperature.
Raise the room temperature.
Replace the Carriage PCB and adjust the temperature with
GT-3 Service Tool.
1061 Temp High:
The ambient temperature is
above the range that maintains
the print quality. “xxx” is the
current temperature.
Raise the room temperature.
Replace the Carriage PCB and adjust the temperature with
GT-3 Service Tool.
1070 Battery Life The battery ran out. Replace the Main PCB battery.
1080 RTC not Adjusted
The internal clock has not been
set.
Set the time with GT-3 Service Tool.
1100 Pump Tube Life Exchange Pump Tube. Replace the Pump Tube.
1111 Clean Tube W1
W1 needs to do Tube
Cleaning.
Execute Tube Cleaning W1.
1112 Clean Tube W2
W2 needs to do Tube
Cleaning.
Execute Tube Cleaning W2.
1113 Clean Tube W3
W3 needs to do Tube
Cleaning.
Execute Tube Cleaning W3.
1114 Clean Tube W4
W4 needs to do Tube
Cleaning.
Execute Tube Cleaning W4.
1200
Exchange
Maintenance Parts
Needs to exchange the
Maintenance Parts and to
clean the printer.
Exchange the Maintenance Parts and clean the inside of
the printer. See "6-1. Replacing Consumables" of the
Instruction Manual.
1201
Exchange
Maintenance Parts
Needs to exchange the
Maintenance Parts and to
clean the printer.
Exchange the Maintenance Parts and clean the inside of
the printer. See "6-1. Replacing Consumables" of the
Instruction Manual.
1210 Exhaust Fan Stop
The Fan to exhaust ink mist is
stopped.
Confirm the Harness in the Exhaust Fan.
Replace the Exhaust Fan.
1220 Exchange Filter K
K/C Filter needs to be
replaced.
Replace with the new K/C Filter on the K Print Head.
1221 Exchange Filter M
M/Y Filter needs to be
replaced.
Replace with the new M/Y Filter on the M Print Head.
1222 Exchange Filter C
K/C Filter needs to be
replaced.
Replace with the new K/C Filter on the C Print Head.
1223 Exchange Filter Y
M/Y Filter needs to be
replaced.
Replace with the new M/Y Filter on the Y Print Head.