2. Setting up GT-3 Series
In [ Step 5:], select “YES” if adjustment is complete, or “NO” if incomplete.
If “YES” is selected, follow the instructions on the dialog and then click [ Next ].
If “NO” is selected, click the [ Re-adjust ] button that appears.
The adjustment is complete when you select “YES” .
The menu returns to [ Step 3:] if “NO” is selected. Enter the previous print results again, follow the
instructions on the dialog, print a test pattern, and then check the result. At [Step 5:], repeat the
adjustment until the conditions allow “YES” to be selected.
The procedure is co
mplete when the following dialog appears.
74
GT-3 Series
To Next Page
Loading...
