3. Operation
3. Select [Pump Pressure] in the Advanced Menu and select [On Carriage] and then the Carriage will move
to the center of the Platen. Insert the Joint into the Hole (5) of the Cap. The Bottle with Maintenance
Solution (4) should be on the table
; or the volume of consumption may be different by the head pressure.
(5)
(4)
(5)
4. Select the col
or you are going to confirm and press the OK button.
5. Weight the Bottle after the menu is finished.
=> The Tube Pump works properly if the current weight is decreased by approx. 38g from the original.
=> The Waste Ink Tubes may be clogged if the current weight is decreased by less than 30g from the
original. Or the Tube Pump may not work properly. Confirm the inside of the Maintenance Unit and
modify the parts (cleaning, exchanging parts).
GT-3 Series 81
To Next Page
Loading...
