HE-800C
3. INSTALLATION
7
3-5. Installing the machine head
1. Place the two bed hinges (1) so that
they are level as shown in the
illustration at left, and then place the
machine head gently on top of the
bed base (3) so that the cables (2) do
not get clamped.
NOTE:
・ The bed base (3) is made from
plastic, so be careful not to hit it
with the machine head when
placing the machine head on top
of it.
・ Make sure that the felt support (4)
do not touch the bed base (3).
2. Install the machine head with the four
spring washers (5) and four bolts (6).
3-6. Installing the head rest
(1) Head rest
NOTE:
Tap the head rest (1) securely into
the table hole.
If the head rest (1) is not pushed in
as far as it will go, the machine head
will not be sufficiently stable when it
is tilted back.
4738M
4739M
4740M
To Next Page
Loading...
