HE-800C
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
33
5-4. Program setting method
It is recommended that you register patterns that are sewn frequently as programs. After programs have been registered, you
can retrieve the desired sewing patterns simply by selecting a program number, which eliminates the need to set the pattern
each time.
Normally up to 50 programs can be registered, and their contents can be changed at any time. The contents can be set by
changing the parameters for each item.
At the time of shipment from the factory, temporary contents are set for programs P01 to P50. (The contents are the same
for all programs from P01 to P50.) Follow the method given below to change the contents of a program before using it.
1
Switch the mode to test feeding mode.
2
Select the program number from P01 to P50 (1) to select the program that you would like to change.
The program No. (1) changes in the order shown in the illustration
each time the key is pressed. (The
key changes the order in
the opposite direction.)
NOTE:
Program mode is not available if a cycle program has been
selected.
3
Switch to program mode.
The parameter number (2) that was last selected and the setting (3)
for that parameter will appear in the display.
* You can also start program mode by pressing a shortcut key. In
this case, the parameter number that corresponds to the shortcut
key will be selected. (Refer to the next page.)
Independent program Cycle program
(Refer to P. 53)
4786M
4918M
4210B
4787M
4211B
4788M
To Next Page
Loading...
