Brother HE-800C - Page 43

HE-800C
5. USING THE SEWING MACHINE (OPERATION PANEL: BASIC OPERATION)
34
4
Select the parameter number (2) for the parameter that you would like to change. (Refer to “5-4-1. Parameter list”.)
5
Change the setting (3) for the parameter.
Flashing
* The flashing display means that the setting has not yet been
applied.
* You can make the initial setting appear in the display by pressing
the RESET key.
6
Apply the changed setting.
Illuminates
* The display will change from flashing to illuminated, and this
means that the setting has been applied.
* You can cancel the setting change by pressing the , ,
AUTO, TEST, MEMSW, R/W or COPY key without pressing the
ENTER key.
7
Repeat steps 4 - 6 above to change other parameters.
Shortcut keys
The shortcut keys have the following six often-used parameters
registered into them.
・ You can retrieve a desired parameter simply by pressing the
corresponding shortcut key.
・ Parameters cannot be retrieved if a cycle program has been
selected.
(4) Zigzag area sewing speed (Parameter No.15)
(5) Length of the hole (Parameter No.02）
(6) Zigzag pitch (Parameter No.07)
(7) Zigzag width (Parameter No.08）
(8) Cutter X space (Parameter No.04)
(9) No. of rectangle underlays (Parameter No.42)
4919M
4920M
4934M
4792M
4212B
4795M
4787M