Configuring your network printer with an Ethernet cable connection
2 - 4
2
3
Select Search Active Devices from the Devices menu. BRAdmin Professional will search for new
devices automatically.
Note
• If the print server is set to its factory default settings without using a DHCP/BOOTP/RARP server, the
device will appear as APIPA in the BRAdmin Professional utility screen.
• You can find the node name and Ethernet address (Node Address above) by printing out the Printer
Settings Page. See Printing the Printer Settings Page on page 8-11 for information on how to print the
Printer Settings Page on your print server.
4
Double-click the unconfigured device.
5
Enter the IP address, Subnet Mask and Gateway (if needed) of your print server.
6
Click OK.
7
With the correctly programmed IP address, you will see the Brother print server in the device list.
Using the control panel to configure your printer for a network
You can configure your network printer using the control panel NETWORK menu. See Control panel setup on
page 8-1.
Using other methods to configure your printer for a network
You can configure your network printer using other methods. See Other ways to set the IP address (for
advanced users and administrators) on page A-1.
To Next Page
Loading...
