Wireless installation in ad-hoc mode (HL-5280DW only)
10 - 17
10
4
If more than one wireless machine is available on
the network, the following list appears. If the list is
blank, check if the machine is powered on, and then
click Refresh. Choose the machine you wish to
configure, and click Next.
Note
The Default Node name of the network card in the printer is “BRW_xxxxxx” (where “xxxxxx” is the last six
digits of Ethernet address).
5
The wizard will search for wireless networks
available from your machine. If more than one
wireless network is available, the following list
appears. Choose the Ad-hoc network you wish to
associate the machine with, and then click Next.
If no Ad-hoc wireless network are available, you
need to create a new wireless network. Go to step 8.
Note
• If your target Ad-hoc network does not appear on
the list, you can manually add it by clicking the
Add button. Follow the on-screen instructions for
entering the Name (SSID) and the Channel
number.
• If the list is blank, check if the machine is within
range for wireless communication. Then, click
Refresh.
To Next Page
Loading...
