Wireless installation in ad-hoc mode (HL-5280DW only)
10 - 19
10
9
Click Next. The settings will be sent to your
machine. The settings will remain unchanged if you
click Cancel.
Note
If you want to manually enter the IP address settings of your machine, click Change IP Address and enter
the necessary IP address settings for your network. After making your selection, click Next and the Wizard
will search for available wireless networks.
10
To communicate with the configured wireless
device, you must configure your Macintosh
®
to use
same wireless settings. Manually change the
wireless settings on your Macintosh
®
to match the
machine’s wireless settings shown on this screen.
Check Checked and confirmed, and then click
Next.
(The settings shown on this screen are for example
only. Your settings will not be the same.)
You have completed the wireless setup. If you chose to install the drivers in step 7,
go to Installing the printer driver on page 10-20.
To Next Page
Loading...
