Chapter 7
46
Identification copying 7
You can copy a photo identification card with
a better and suitable quality by using this
feature.
a Make sure you are in Copy mode .
b Place the Identification card face down
on the scanner glass.
Even if a document is set on the
ADF, the machine scans the data
from the scanner glass.
c Press Options.
Press a or b to choose Text & Graph.
Press OK or c.
d Press Start.
• When Text & Graph is chosen, the
machine sets the quality to Photo and the
contrast to +2 (-nnnno+).
• After the copying is finished, the machine
will go back to Copy mode and the copy
settings will return to the settings that you
set just before that.
Improving copy quality 7
You can choose from a range of quality
settings. The default setting is Auto.
Auto
Auto is the recommended mode for
ordinary printouts. Suitable for documents
that contain both text and photographs.
Text
Suitable for documents containing mainly
text.
Photo
Better copy quality for photographs.
Graph
Suitable for copying receipts.
To temporarily change the quality setting,
follow the steps below:
a Make sure you are in Copy mode .
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Options.
Press a or b to choose Quality.
Press OK.
e Press a or b to choose Auto, Text,
Photo or Graph.
Press OK.
f Press Start.
To change the default setting, follow the
steps below:
a Press Menu, 3, 1.
b Press a or b to choose the copy quality.
Press OK.
c Press Stop/Exit.
To Next Page
Loading...
Need help?
General
