11 - 4 USING THE MFC AS A PRINTER
Manual Duplex Printing
The MFC prints all the
even-numbered pages on one
side of the paper first.
Then, the Windows
®
driver
instructs you (with a pop-up
message) to reinsert the paper.
Before reinserting the paper,
straighten it well, or you may get
a paper jam. Very thin or very
thick paper is not recommended.
We recommend 20 to 24 lb (75 to 90 g/m
2
) paper.
Face-down output tray
The MFC ejects paper with printed surfaces face down into the
output tray in the front of the MFC. Unfold the support flap to support
the printed pages.
When printing transparencies, remove each one from the
support flap after it exits the MFC.
Support Flap
with Extension
To Next Page
Loading...
