Brother MFC-8440 - Test Switch; Paper Tray #2

OPTIONAL ACCESSORIES 23 - 9
Active LED is yellow:
The Active LED will blink if the print server is receiving or transmitting data.
TEST SWITCH
Short push: Prints the network configuration page.
Long push (more than 5 seconds): Reset the network configuration
back to the factory default settings.
Paper Tray #2
You can purchase the Paper Tray #2 accessory (LT-5000) to use as a
third paper source. Tray #2 holds up to 250 sheets of 20 lb (80 g/m
2
)
paper.
If there is a valid connection to the network, the LED will blink
orange or green.
To set up the MFC on the Network, see the NC-9100h Network
User’s Guide
on the CD-ROM.
Paper Tray #2 Holds approx. 250 sheets of 20 lb (80 g/m
2
)
Basis Weight 16 to 28 lb (60 to 105 g/m
2
)
Moisture Content 4% to 6% by weight
We Recommend:
Cut sheet:
Xerox 4200 DP 20 lb
Hammermill Laser Paper 24 lb
LED
LED
Ethernet
RJ-45
Test Switch