Brother MFC-9465CDN - Page 134

2-95
Confidential
■ Error code E4
Run out of paper.
This error does not usually occur in the normal use. The conceivable causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
<User Check>
- Turn OFF the power switch, and turn it ON again after a while.
■ Error code E6
Write error in EEPROM of the main PCB.
■ Error code E7
Main PCB error.
This error does not usually occur in the normal use. The conceivable causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
<User Check>
- Turn OFF the power switch, and turn it ON again after a while.
---
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
Print Unable E6
Turn the power off and then back on again.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
---
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.