Brother MFC-9465CDN - Page 481

5-43
Confidential
<Operating procedure after adjustment inter-color position alignment (auto)
fails>
1) Press the 6 button twice in the initial state of the maintenance mode.
"REGISTRATION" is displayed on the LCD. Load paper on the tray.
2) Press the or button to display "PRINT CHART" on the LCD, and then press the
OK button.
3) Display "PRINTING" on the LCD, and print the inter-color position alignment
adjustment chart. After printing, "PRINT CHART" is displayed again.
4) Press the or button to display "OFFSET ADJUST" on the LCD, and then press
the OK button. "1. MAGENTA = 0" is displayed on the LCD.
5) With the printed inter-color position alignment adjustment chart, check the numeric
value where the color is the darkest among the pattern (Magenta Left). Press the
or button to display that numeric value, and then press the OK button.
6) Enter the numeric value of the patterns to and to in the same way.
7) When you enter the numeric value of the pattern (Yellow Right), "COMPLETED" is
displayed.
8) Press the Stop/Exit button to return to the machine to the initial state of the
maintenance mode.
■ Adjustment of inter-color position alignment (manual)
<Operating procedure>
(1) Press the 6 button twice in the initial state of the maintenance mode. "REGISTRATION" is
displayed on the LCD. Load paper on the tray.
(2) Press the or button to display "PRINT CHART" on the LCD, and then press the OK
button.
(3) Display "PRINTING" on the LCD, and print the inter-color position alignment adjustment
chart. After printing, "PRINT CHART" is displayed again.
(4) Press the or button to display "SET REGISTRATION" on the LCD, and then press
the OK button. "1. MAGENTA = 0" is displayed on the LCD.
(5) With the printed inter-color position alignment adjustment chart, check the numeric value
where the color is the darkest among the pattern (Magenta Left). Press
the or button to display that numeric value, and then press the OK button.
(6) Enter the numeric value of the patterns to in the same way.
(7) When you enter the numeric value of the pattern (Yellow Right), "COMPLETED" is
displayed.
(8) Press the Stop/Exit button to return to the machine to the initial state of the maintenance
mode.
1
2 3 7 9
9
1
2 9
9