Brother MFC-T910DW - Page 44

Home > Paper Handling > Load Paper > Paper Settings > Change the Check Paper Size Setting
Change the Check Paper Size Setting
Related Models: DCP-T510W/DCP-T710W/MFC-T910DW
If the Check Paper setting is set to [On] and you pull the paper tray out of the machine or load paper in the MP
Tray, the LCD displays a message asking if you want to change the Paper Size and Paper Type settings.
The default setting is [On].
>> DCP-T510W/DCP-T710W
>> MFC-T910DW
DCP-T510W/DCP-T710W
1. Press Menu.
2. Press a or b to select the following:
a. Select [General Setup]. Press OK.
b. Select [Tray Setting]. Press OK.
c. Select [Check Paper]. Press OK.
d. Select [On] (or [Off]). Press OK.
3. Press Stop/Exit.
MFC-T910DW
1. Press Settings.
2. Press a or b to select the following:
a. Select [General Setup]. Press OK.
b. Select [Tray Setting]. Press OK.
c. Select [Check Paper]. Press OK.
d. Select [On] or [Off]. Press OK.
3. Press Stop/Exit.
Related Information
• Paper Settings
• Load Cut-Sheet Paper or Photo 2L Paper in the Paper Tray
• Load Photo Paper in the Paper Tray
• Load Envelopes in the Paper Tray
• Error and Maintenance Messages
38