GETTING STARTED
18
Turning Power On/Off
Close the Rear Cover.
Press the (Power) button to turn the printer on.
Press and hold the (Power) button again to turn the printer off.
Auto Power-Off Time
If you use the AC adapter or Li-ion battery, you can change the setting of the auto power-off
time.
Press the Menu key, select “Auto Power Off” using the or key, and then press the
OK or Enter key.
Select the battery shown on the LCD by using the or key and set the value using
the or key.
“AC Adapter” or “Li-ion Battery” can be selected.
Press the OK or Enter key.
• Place the printer on a flat surface as shown in the
illustration, and then attach the Rear Cover.
• If you cannot attach the Rear Cover, ensure the white
lever (1) is in the up position. If not, lift the lever, and then
attach the cover.
• Do not pull the label coming out of the Tape Exit Slot. Doing so will cause the ink ribbon to be
discharged with the tape. The tape may no longer be functional after the ink ribbon discharges.
• Store tape cassettes in a cool, dark location, away from direct sunlight and high temperature,
high humidity, or dusty locations. Use the tape cassette as quickly as possible after opening the
sealed package.
Extra Strength Adhesive Tape:
• For rough and textured surfaces, we recommend using Extra Strength Adhesive Tape.
• Although the instruction sheet included with the Extra Strength Adhesive Tape cassette
recommends cutting the tape with scissors, the Tape Cutter that this printer is equipped with is
able to cut Extra Strength Adhesive Tape.
Turning Power On/Off
Your printer has a power saving function and automatically turns itself off if no key is pressed
within a certain time, under certain operating conditions. For more information, see “Auto Power-
Off Time” on page 18.
When you use alkaline batteries or Ni-MH batteries, the auto power-off time cannot be changed.
(The time is fixed to 20 minutes.)
To Next Page
Loading...
