Brother P-touch E550W - Setting Character Attributes; Setting Character Attributes by Label; Setting Character Attributes by each Line

8
1
2
3
4
5
6
7
9
10
29
Setting Character Attributes
ENGLISH
 EDITING A LABEL
Setting Character Attributes by Label
Using the Style key, you can select a font and apply size, width, style, line, and alignment
attributes. Selectable “Character Attribute” options are listed in the Appendix. (See page 86.)
Press the Style key.
The current settings list appears.
Select an attribute using the or key, and then set a value for that attribute using
the or key.
Press the OK or Enter key to apply the settings.
Setting Character Attributes by Each Line
When a label consists of two or more lines of text, you can set different values of character
attributes (font, size, width, style, line, and alignment) for each line.
Move the cursor to the line you wish to modify by using the , ,
or key. Next, press the Shift key, and then press the Style key
to display the attributes. ( on the screen indicates that you are
now applying the attribute for that specific line only.)
Setting Character Attributes
1
2
3
New settings are NOT applied if you do not press the OK or Enter key.
•Press the Esc key to return to the previous step.
•Press the Space key to set the selected attribute to the default value.
• Small characters may be difficult to read when certain styles are applied (e.g. Shadow + Italic).
• Depending on the labelling application type, you cannot change the value in Style setting. In this
case, is displayed on the preview in the right side of the screen.
When different attribute values are set for each line, the values will be
displayed as ***** when you press the Style key. When you change
the setting on this screen using the or key, the same change will
be applied to all lines.